Home Drone How to Build a Drone: Alien 2 Hour Build Time Lapse in 8 Minutes
0

How to Build a Drone: Alien 2 Hour Build Time Lapse in 8 Minutes

218
0

This is an 8 minute Time Lapse video from 2 hours of non-stop building. I did have a few things pre-built to put in which you wont see, but I made this video hoping there would be someone who watches this and things “Hey!.. I can do this” If your considering getting into the hobby, you can do it… There is much support out there and with some patience and research, you can do it also 🙂

Acronym Glossary

ESC = Electronic Speed Controller (They act as a middle man between the Flight controller and motors to tell them how fast to spin. ESCs in this build are Flyduino Kiss24A ESCs
PDB = Power Distribution Board. This PCB takes 4-cell (4S) Lipo battery power and branches off to allow the ESCs and Flight controller to get some juice aswell. I fly with 4S 14.8V Batteries (Lots of power), New guys often fly with 3-Cell (3S batteries until they feel comfortable upgrading.
FC = Flight Controller. This is a printed circuit board with a micro controller which calculates and controls motor speed through PID loops.
RX = Receiver. This is a transceiver which receives and sends data between the radio controller and flight controller
VTX = Video Transmitter. This takes the video from the FPV camera and broadcasts it across the 5.8ghz spectrum on a specified channel. Im using a TBS Unify Pro in this build.
VREG = Voltage Regulator. This takes the 4S 14.8V and steps it down to 5V for the Video Transmitter.
CBF= Cant be F**ked… When I have had enough of building 🙂

Please LIKE if you do and Subscribe to support Vek FPV. Thanks!

Follow me:
Website: http://www.vekfpv.com
Instagram: https://www.instagram.com/vek_fpv/
Twitter: https://twitter.com/vektaur

// Quad //

Alien 5″ from Impulse RC
Kiss Flight Controller
Kiss 24A ESC
Motors: Venom 2205 2300KV
Props: 5x4x3 HQ
HS1177 FPV Cam @ 30Degrees
Foxeer 5.8 VTX w/ Aomway RHCP Antenna
1300mAh 75C Aga

// Transmitter/Receiver //

FrSky Horus X12S
X4R on SBUS

// Video //

Go Pro 4+ Silver 1080p 60FPS
3D Printed Protective Case
Layer Lens

// FPV & GroundStation //

Fat Shark – Dom HD V2’s
La Forge Diversity Combo w/ Aomway Omni & Irc 8dbi Patch

Massive thanks to Impulse RC, HQ Props & Flyduino for making the sickest quad gear!

http://www.impulserc.com
http://www.hqprop.com
http://www.flyduino.net
http://www.westcoastmultirotors.com.au/

source

Comments

comments

×
Like us on Facebook
No Thanks
×
Did you like it?
Share it on Facebook
No Thanks